Found Deep Fender Braces

[Boris]

Need a complete set of four. Rusty is preferred.
1) The flat curved surface of brace that attaches to fender needs to be at least 5 1/4" before the exposed raised portion begins.
2) From the edge of fender to the center of axle hole is 12".*
3) Total length of brace is 29 1/4" from center of axle hole to center of axle hole.*

*measurement taken on edge of brace rather than over the raised portion.

 

[kirk thomas]

If you have a picture I'm pretty sure I have what you need. Thanks, Kirk

 

[Boris]

Thanks. Trying to make these non-Colson fenders work. Sent you a PM.

 

[Boris]

Still looking. Kirk checked and didn't have any this size. These may be either Wald or McCaully fenders if that helps any.

 

[Boris]

BUMP

 

[Boris]

I'll lay off the puns for a while for a set of these braces. Terms to be discussed.

 

[Boris]

I still need these.

 

[vincev]

I still need these.

How does it feel to "want" ? I still want a drop stand for a 26 incher.

 

[Boris]

Quit bragging!

 

[Greg M]

Misplaced a decimal point there Vince?