baronvoncatania
Finally riding a big boys bike
I've done these overhauls before, not too bad to do. This time I replaced the three sets of ball bearing, and the disk set. I aligned all the disks with a straight edge and for the life of me I could not slide the assembly back into the hub without knocking the disks out of alignment.
Apparently there is a disk alignment tool part# d25 that locks them in place. I don't have one.
How do you all accomplish this job?
Thanks jim
Apparently there is a disk alignment tool part# d25 that locks them in place. I don't have one.
How do you all accomplish this job?
Thanks jim