You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
no matter how I adjust belt hits tire and flat of whizzer fender!
Is there a spacer I might need behind the clutch pulley ? I am trying to get a 1 1/2 measurment from the rim edge to the outside of seat and chain stays. I'm lost.
The frame is dimpled.I measure 11/2" on both sides from edge of rim to outside of chain stay and seat stay. But belt stays closer to wheel. I might have a wheel dish prob or what I don't know.GRRR
Try loosening up the motor mounts and adjusting the engine out a tad so the pulley is out too away from the frame. I had to do that to get the belt to clear the frame.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.