Search results

Here’s the Murray all finished up. Might go with fenders, but I’m not sure.

No brand name, but they’re well made and are quite comfortable. https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F122431664622

So I’ve built a few bikes over the years. Fixies, singlespeeds, kids bmx, even my tri bike and enduro mountain bike. I think I enjoy building them more than riding! So this time it started with a mid-90’s KHS hybrid cruiser a neighbor was tossing. Figured it had Ben awhile, and my daughter...

I’ll check it out, thanks. I took the frame to a local shop and test fit a standard 1 1/8” threadless cup and it seemed to be a good fit. I’ll likely just get a threadless fork and pair it with the threadless headset and the threadless stem I’d already bought.

I need a headset for this 70’s era Murray. Headtube ID is 34mm. I was planning on using a 1” threaded fork. The headset I ordered has cups that are too small. The only headsets I can seem to find with cups to fit 34mm, are meant to be used with a 1 1/8” fork. I dont mind switching to a...

Thank you everyone...that’s a great place to start. Based on the Murray thread here, it seems that it would be a 62 based on the serial starting with a “U”. Did they start over with the numbers in the 70’s?

Hey folks...new here but I’m loving all the info I’ve seen so far. I just picked up this frame to build up for my daughter. It’s been powder coated, but I can still make out a serial number stamped vertically on the left side of the head tube: U4059215. The seller though it was a 60’s...