Hey guys. I need some SERIOUS help here. I cannot find the correct way to route my shifter cable for my 1955 Radiobike's Bendix 2-speed hub. I even have an untouched '55 Customliner 2-speed to compare to, but that is women's bike and is probably routed differently. I do not have detailed pics of...
Hi, I need a SA cable for a 1955 Schwinn lightweight with SA 3 speed set up. I have the shifter and hub and a cable in horrible condition. It measures 18" housing and 55 1/2" total length. The shifter has just a small hole for where the cable goes, not a key hole shaped slot so I am not sure...
Very nice 1970's new old stock stamped SCHWINN APPROVED plastic coated cable in a copperdust/bronze finish.
Great for your period bike!
SOLD thanks CABE!
This is a New Departure DD hub with the cable the shifter and two cable pulley wheels that attach to the frame . I was told it works & it feels like it does from what I can tell with out it being on a bike . This is exceptionally clean The price is $400 shipped to your door in the USA . Pay pal...
Bump reduced price on the NOS seat parts
NOS Lot of 1920s-30s TROXEL prewar long spring seat chassis parts...lots
of good useable stuff including a left and right Rail set for the wire frame
Mens longspring chassis, hard to find correct LONG Carriage bolts for the
spring assemble, complete nose...
Up for sale, three Stewart Warner speedo drive cables. New old stock, $30 mailed. paypal ok. First to converse if interested. Thanks First to converse if interested. Thanks
Hi! Can anyone tell me the significance of these cables I have being black outer housing, as well as having a rubber hood that covers one end? Most I'm seeing on the internet are grey, and do not have the hood,
Also, could you identify which bikes / sizes these lengths of cables might go to...
not sure but think this must becearly the thread portion of actuator connecter is smaller than anything else I have $100 obo ff/pp shipped 48 usa pm to buy
Not sure of the application. It does mate up to a Stewart Warner. MISSING inner cable. Appears to have been replated not painted.
$65 shipped OBO
Thanks
Chad
Has the original Stingray Head, think it’s a Huret?
Don’t know a lot about these, but the cable shot. The drive and parts seem ok though. I can pay USPS money order. Thanks a bunch.
I need a gently used or NOS shifter cable and linkage for a Sturmey-Archer 3-speed for my '59 Schwinn Corvette. I would like to find original parts so I can keep the original look, and especially the shifter. If your cable comes with a shifter, please get me pics of it, it must be exactly the...
Original Schwinn brake cable used pre and early post WWII. WILL NOT FIT DRUM BRAKE. This cable will only work with front caliper brakes. Original cable and lining. $35 shipped obo
$2,800 shipped in USA
Honest and original super early chopper with the following intact; reverse rear brake with long braces, cable routed inside the chopper frame tube, down turned cleat, Dimpleless "RALEIGH" front wheel, correct "Italian" rear rim, 3+2 early bell crank, single tab front...
BUY IT BY THE FOOT.
NOS STAINLESS CABLE SHROUD, THESE PIECES GO FROM TANK TO FENDER OR LIGHT
PRICE: $10 PER FOOT
Kindly note : I will only ship this item to the USA.
Location:WEST DES MOINES, IOWA
ATTENTION: NO PAY PHONES WERE HARMED IN THE POSTING OF THIS ITEM!
i need the Skylark speedometer cable. longer than the normal bicycle length. its all i need to complete my Robin. a reproduction is ok too. PLEASE HELP!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.