You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
spacer Using an appropriate fiber/woven/abrasive end-cutter on your Dremel or your Foredom ... CUT THE COWCATCHER OFF THE TANK.
Your measurements need to be accurate.
Use an index-card to design a working-pattern of the repair / filler-piece.
When you are satisfied with fit ... transfer this index-card information to a piece of suitable sheet-metal.
Do not do anything heroic. Measure, then check your measurements -- before any scoring, clipping and
bending of the sheet metal.
When you sense your accuracy ... clean everything with lacquer-thinner and attach the filler-piece in
a manner that makes it obvious you respect what you're working on.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.