You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Thin style... remove stem bar cinch bolt, slide bar onto neck opening and then slip x-bar end tab through neck opening and on thru.
Thick early x-bar... same procedure, except may need to pry cinch opening apart a bit. Pry Slooooowly as to not crack metal and just enough to get x-bar end tab through. use what ever tool will not damage your stem.
Note: Make sure bars are not going on backwards! Ha!
Classic technique for spreading the cinch open: Pull out the bolt flip it over and start threading it in from underneath. Put a penny or something in the slot and slowly tighten the bolt. When done back out the bolt and remove the penny.
Classic technique for spreading the cinch open: Pull out the bolt flip it over and start threading it in from underneath. Put a penny or something in the slot and slowly tighten the bolt. When done back out the bolt and remove the penny.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.