Measurements for drilling Pogo shock pins into sissy bar- Krate

[427Krate]

I am converting a regular sissy bar into a pogo sissy for a Krate. I have all the parts however I forgot where I am supposed to drill holes to install the pins.

Does anyone have instructions or measurements on how to do this. I believe they used to be on the hyperformance website but now they’re gone.

 

[stingrayjoe]

Holes appear to be 5/32"

 

[xochi0603]

Hello, I've done it before. I clamped the new & old sissy bar together & used a small drill press. Worked great! Good luck

 

[427Krate]

Thank you, that is helpful. I should be able to figure out what order the parts go back in once I get started.

 

[stingrayjoe]

From: T.A. Gordon's & Jim Hurd's book