You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
True, each side is now $92. There are 2 front and 2 rear. The fronts are listed on the website too. They were $75 each when I bought them but that was 20 years ago. The style they have now are slightly different but very cool. I can post the link if you can’t find them.
True, each side is now $92. There are 2 front and 2 rear. The fronts are listed on the website too. They were $75 each when I bought them but that was 20 years ago. The style they have now are slightly different but very cool. I can post the link if you can’t find them.
If you don't mind. I just quickly looked and only seen the rear for 26" bicycles. I will have to debate these myself for my Monark/Nirve motorcycle build .
If you don't mind. I just quickly looked and only seen the rear for 26" bicycles. I will have to debate these myself for my Monark/Nirve motorcycle build .
It’s hard to see but the current version has a lip that goes over the flange of the wheel all the way to the tire. The first generation that I have only goes down to the flange and angles out. I put foam tape on the inside of the disc before installing. It eliminates the rattling when you ride on them.
They are spun aluminum with NO clear coat. It’s a large surface area and relatively thin. I would think it would be tough to polish evenly without putting dents in them
They are spun aluminum with NO clear coat. It’s a large surface area and relatively thin. I would think it would be tough to polish evenly without putting dents in them
Thank You Good Sir. That influences me not to wanna polish them & may make me wait on getting them. I have been building the bike as a bike and still have to cut & weld for my end goal so $400 some buckeroos on covers will go way back. They look Absolutely Great but Priorities 1st. Thanks again
Thank You Good Sir. That influences me not to wanna polish them & may make me wait on getting them. I have been building the bike as a bike and still have to cut & weld for my end goal so $400 some buckeroos on covers will go way back. They look Absolutely Great but Priorities 1st. Thanks again
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.