When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Poor Man's Fender Roller

#eBayPartner    Most Recent BUY IT NOW Items Listed on eBay
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture

TR6SC

I live for the CABE
Nothing ultra-techno to be found here, but a couple radii to pound against for that fender that needs a little "attitude adjustment."
I used a hole saw which is about as thick as a fender. The slots in the round leave clearance for the edge roll.
IMG_0940.JPG

The blocks can be used as a set, or either one can be mounted in a vise and used with a soft hammer.
IMG_0941.JPG
 
I’m pretty simple. I chucked the caster in a hand drill. Spun the caster up against my disk sander and shaped different wheels.
The unintended benefit of using the Jorgensen clamp was being able to change the angle of the wheel. I could make it pinch down on either side of the main wheel which allowed me to be able to go right up against an edge seam or right up to the peak of a Roadmaster fender.
 
Back
Top