bobcycles
Riding a '38 Autocycle Deluxe
Three varying fender lots!
Shipping extra ...
[email protected]
or PM here
#1. 2 useable prewar Schwinn Motorbike fronts as found... Maroon / Dark red one is for the Silver Ray
headlight or Hornlight, correct holes for 1936 up. Underneath there is some heavy bondo in a few areas..
not sure what happened there, out side looks "ok", not spectacular but useable.
The other has no holes..could be Autocycle Fender bomb specific.... Definitely has been trimmed
slightly at the tail. OG 30's Schwinn fronts...
75.00 pair
#2. Misc lot of 5 fenders. The wide ones are Prewar Wald I am guessing designed after the Schwinn prewar
fenders with the wide Fork and Truss notch on each side. Excellent condition and I will say, the rear is an
ideal candidate for a 1936 wide fender Motorbike or Double bar roadster etc. Drill 2 fender brace holes higher
and the fender is practically a dead ringer for the Schwinn version.
The other 2 matched pair I believe are Cleveland Welding or Prewar Rollfast. They match and have flat
braces and are relatively straight.
125.00 for all 5
#3. Pair of Prewar Colson Bullnose, Clipper, Grill Tank, Blistertank, etc 39' there abouts through 41 fenders ... one brace missing.
Some dings and dents but tough to find when you're building that specific Colson cruiser
60.00 for the pair
Shipping extra ...
[email protected]
or PM here
#1. 2 useable prewar Schwinn Motorbike fronts as found... Maroon / Dark red one is for the Silver Ray
headlight or Hornlight, correct holes for 1936 up. Underneath there is some heavy bondo in a few areas..
not sure what happened there, out side looks "ok", not spectacular but useable.
The other has no holes..could be Autocycle Fender bomb specific.... Definitely has been trimmed
slightly at the tail. OG 30's Schwinn fronts...
75.00 pair
#2. Misc lot of 5 fenders. The wide ones are Prewar Wald I am guessing designed after the Schwinn prewar
fenders with the wide Fork and Truss notch on each side. Excellent condition and I will say, the rear is an
ideal candidate for a 1936 wide fender Motorbike or Double bar roadster etc. Drill 2 fender brace holes higher
and the fender is practically a dead ringer for the Schwinn version.
The other 2 matched pair I believe are Cleveland Welding or Prewar Rollfast. They match and have flat
braces and are relatively straight.
125.00 for all 5
#3. Pair of Prewar Colson Bullnose, Clipper, Grill Tank, Blistertank, etc 39' there abouts through 41 fenders ... one brace missing.
Some dings and dents but tough to find when you're building that specific Colson cruiser
60.00 for the pair
