Somebody has to have some instructions!

[Saving Tempest]

Okay...I finally located where I put the 6mm stem tool.

I removed the bolt from my 1995 Cruiser SS.

That doesn't seem to be enough.

How do I get the rest of this two piece stem out?

 

[Saving Tempest]

 

[rustjunkie]

Thread the bolt back in then give it a rap with a mallet, no dif than an old stem

 

[Saving Tempest]

So you want me to put it back together and tap it with my hammer, they try again?

 

[rustjunkie]

It comes out like any wedge-type stem, see the Schwinn manual

 

[Saving Tempest]

It's just not budging, and I had to install the one on my Hornet AND remove it a couple times.

PS WHAT manual? It was fully assembled when it was given to me several years ago. I'm trying to put a conventional stem on it, and that will be a bit shorter.

 

[Saving Tempest]

I'll try to twist it back and forth to see if it works out.

 

[rustjunkie]

I think it’s in here:

https://thecabe.com/forum/threads/schwinn-service-manual-volume-1-2.96855/

 

[Saving Tempest]

 

[Saving Tempest]

Just leaves me confused, there must be a taller stem.