What bike did you work on today?

[Sven]

A flat tire puts this one on the rack this morning

 

[JRE]

Started working on the 35 Shelby non wishbone framed bike. Trying to figure out how the get the bearing retainer nut off that previous owner put on backwards.

 

[JRE]

Started working on the 35 Shelby non wishbone framed bike. Trying to figure out how the get the bearing retainer nut off that previous owner put on backwards.

View attachment 1176638

 

[Nashman]

New rubber and dial in the '49 CCM ( 28" x 1 1/2" wheels) 3 speed Sturmey archer drum brake. New ( NOS/Scott) ballends, Troxel saddle, Bevin bell, Winnipeg plate.

 

[Nashman]

View attachment 1176642

Can you get a punch pin tool into the inner slot and tap with a hammer to reverse the cone off the threads ? Ensure you are loosening it. Murphy's law, I'd hit it the wrong way and tighten it.

 

[Nashman]

A flat tire puts this one on the rack this morning
View attachment 1176130

I dig the old beer cans too!! Cheers!

 

[JRE]

Lol yea was going to try getting something into the slots or going 2 flat spots on the cone so I could use. Wrench

 

[oldfart36]

Spending some time with my 1939 OG faded out Monark "hanging tank" Rocket motorbike. Think it's time for some "clay/brick", US Royal Chains!

 

[fordmike65]

Finally found the time last week to dig out and partially disassemble my '36 Colson doublebar with the separated chainstays. Not uncommon on these earlier LWB frames. I cleaned out the inside of the BB before having my bud Steve @Velocipedist Co. repair it so well it will never happen again. You'd never know it was ever touched. Today I was able to reassemble it and take it for a quick spin. I can't believe it's been 3yrs since the last time I rode it.

 

[GTs58]

That must have been a real pain to get inside the BB shell to do that fix.