What does your current project look like now?

[Sped Man]

I switched out the pinstriping on a good set-o-rims for my C model.

Awesome! So that is how it is done. Sweeeeeeeeeeeeeeeeeeeeet! Where can I pick up one of those rim pin striping tools?

 

[jacob9795]

My Daddy had this one in his shop. I saw one on eBay. It’s a fun tool to use, first time for me.

 

[jacob9795]

Patina restoration on my badge. I sent my saddle top to Bob U this week.

 

[jacob9795]

Tonight I laced up a Small Flange Fore-Wheel Brake for my ride. The spokes were rusted so I dipped them in CHEM-DIP for a few minutes followed by a light scrub using extra fine steel wool. Then I dipped the spokes in concentrated HCl for a few seconds followed by a good rinse. The ‘high side’ spokes needed to be trimmed about 2mm so the rim sits dead-center in the fork (rim centering). I installed some Good Year All Weather G-3 tires.

 

[buickmike]

I love the look of painted rims. That's how I built up a 37 motorbike. After many years of looking at it I decided the drum brake deserved to have the hoop in the same finish. For now it has Murray (M.O. stamped) rims. Although my bike was not original paint. This c model appeared as if it was built this way.

 

[mike j]

46 DX, aka" El Burro".

 

[eddie_bravo]

New project as of today
Just needs to be torn down, cleaning and 1 grip, looks like that’s about it. Got it today from my neighbor

Eddie Bravo
Sent from my iPhone using Tapatalk

 

[oldfart36]

Project! "1/2 And 1/2.
Mock up before frame paint.
1948 JC Higgins using a 40's Hawthorne front end. Front end, headlight, tank, bobbed rear fender, and youth seat top, will be sealed bare metal, while frame will be painted. Really have gotten to enjoy the bare metal stuff for Rats!

 

[JimRoy]

1920s DP Harris Rollfast: I test road yesterday. Waiting on a couple more parts, and then paint and final assembly. I started this project 12/27/17

 

[PlasticNerd]

Working on this now