pedal4416
Cruisin' on my Bluebird
There’s been a lot of requests for this lately. I can also make printouts to mail out.
I’ve used this a few times on fenders. You may need to trim more than shown on the template especially where the fender meets the seat stay. I trace this out on printer paper then cut it out and tape it to the fender, then I trace it with a sharpie. I use sheet metal snips to start it then a dremel with a cutting wheel, then sanding barrel. Message me with any questions.
I’ve used this a few times on fenders. You may need to trim more than shown on the template especially where the fender meets the seat stay. I trace this out on printer paper then cut it out and tape it to the fender, then I trace it with a sharpie. I use sheet metal snips to start it then a dremel with a cutting wheel, then sanding barrel. Message me with any questions.