WTB: Delta Frontloader

  • Regarding bumping ads in the classifed forums, we've just installed a new (customized) add-on that will change the way ads are bumped to the top. Please refer to the post "Bumping Classifed Ads" for details.
Most Recent BUY IT NOW Items Listed on eBay
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
eBay Auction Picture
These ads go away when you register for an account!

jpromo

Cruisin' on my Bluebird
May 26, 2011
3,881
Plymouth, Michigan
WTB: Dropstand, no ears

I picked up a '38 Columbia which turns up with both a Horn-lite or a Torpedo. Mine has no provisions for wiring so Torpedo it is.

Any help is appreciated! Thanks.
 
Last edited:

jpromo

Cruisin' on my Bluebird
May 26, 2011
3,881
Plymouth, Michigan
Alright, after doing some digging, I believe the light pictured here is correct for my bike.

194020columbia20westfield20airrider-1.jpg
 

jpromo

Cruisin' on my Bluebird
May 26, 2011
3,881
Plymouth, Michigan
Overheard at a future bike show: "Yeah, it's the one with the Tonka on the fender."
 

scrubbinrims

Riding a '38 Autocycle Deluxe
Sep 2, 2010
6,771
4900 New Kent Rd, Richmond, VA 23225, USA
Did you see my wavy top delta front loader in my case?
It is quite nice, original creme paint and original to your bike.
Chris
 

jpromo

Cruisin' on my Bluebird
May 26, 2011
3,881
Plymouth, Michigan
Did you see my wavy top delta front loader in my case?
It is quite nice, original creme paint and original to your bike.
Chris
Ah, that sounds very familiar now. I knew my light wasn't correct but I did not know what was at the time. Sending PM.
 

jpromo

Cruisin' on my Bluebird
May 26, 2011
3,881
Plymouth, Michigan
Light found; thanks Chris. Now how about a dropstand without tangs/ears? I need around 13 1/4" to 13 1/2" from the center of the holes to the inside of the bottom channel.
 
Last edited:
This ad goes away when you register for an account!