1961 Bendix Two Speed Automatic Disassembly Question

[Krakatoa]

OK... So the assembly doesn't come apart anymore after this you have to snap the old bearing off and new one on?

 

[WillWork4Parts]

OK... So the assembly doesn't come apart anymore after this you have to snap the old bearing off and new one on?

The assembly does come apart further. The condition of the bearing cage and balls don't look that bad, it should come off AND go back on. ... without that much effort.

If you're thinking the splined section comes out of the center of the inner race, no that does not work that way.

 

[Krakatoa]

I guess I was overthinking it but I did what you guys said and lifted it up by one edge and it popped right over.

 

[Schwinn Sales West]

In the good ole days when parts were cheap and plentiful you would just replace the retainer with a new one. If you don't have a new, or a good used retainer, nothing is wrong with just popping new balls into your old retainer.

The bearing surface looks a little rough on your cone. But keep in mind they were not that great even when they were brand new. If it doesn't "have any cavities" just run it.

It goes without saying pay attention to the printed directions on the retainer "this side out".

John

 

[drglinski]

What you have in your hands in the last photo does not come apart any further. Great job getting the dust cap off, it can be a PITA.

 

[Mymando]

There’s plenty on eBay right now!!