Bendix Sturmey Archer Shimano 24 and 28 tooth rear sprockets

[MEKANIXFIX]

Hola and hi, to the caber! I received the 28T for Bendix 3 cogs; and hearts design
, very nice item,and very nice metal work! Gracias

 

[SKPC]

OK Cabers, an American product worth stocking up on. Skip tooth and 1/2" chain three-tab custom cogs by Mike. CCBM. I wrapped a section of NOS diamond chain around the entire cog and tooth contact was 100% tight to all rollers, nice. This 12t cog went on cleanly with no slop to my TCWIII three speed coaster hub driver, replacing a 10t cog I was using. Spacers and snap ring retainer set in tightly. Perfect 3mm thickness, beautiful brushed finish. I added a small length of new chain to the Shelby and rode it for a mile or so. Shelby fans? What a match. Smooth and quiet, much better of a middle gear with the big 26t Shelby chain ring. I will be following up on it next long ride on this bike. The Neutral/High two speed kickback bikers out there take note!
Line up folks, this is one fine piece. I suggested to Mike a 10, 11, 12 & 13 tooth option 1" pitch of this 3-tab design below, both drivers. Simple and useful what a concept. Fine job Mike. pete

 

[Old'n'Slow Bikes]

Thanks Pete! I will do just a bit of small fine tuning on this as we discussed, and then put them on the market.

 

[SKPC]

Pulled off a 22 miler yesterday after the rains running the 12t skip sprocket. Smooth and quiet. With a big 26t sprocket in front with this 12t cog in back, nuetral is better imo. Low seems more useable and High is now not too high and I used it more. Mike has a couple secret upgrades coming to these, so will have to wait a bit to see what's next...even without improvements, this ran very nice. 12 & 13 tooth, can't see an 11?

 

[Miq]

Rode 12 miles today with this 24T from Mike on my F&S 3-speed. It worked great.

 

[Old'n'Slow Bikes]

Pulled off a 22 miler yesterday after the rains running the 12t skip sprocket. Smooth and quiet. With a big 26t sprocket in front with this 12t cog in back, nuetral is better imo. Low seems more useable and High is now not too high and I used it more. Mike has a couple secret upgrades coming to these, so will have to wait a bit to see what's next...even without improvements, this ran very nice. 12 & 13 tooth, can't see an 11?
View attachment 2186779

View attachment 2186782

Thanks

 

[Old'n'Slow Bikes]

Thanks for the kind words! I will have a 12 tooth skip tooth ready by the end of the week!

 

[byke!punk]

Awesome! Mark me down for a couple of them 12 tooth Sweethearts!

 

[Old'n'Slow Bikes]

Awesome! Mark me down for a couple of them 12 tooth Sweethearts!

Should be ready very soon!

 

[mrg]

I’m guessing Fichtel & Sachs hubs are the same as the ones that just say sachs?